Description

This rectifier is for powering high voltage single color (2-conductor) LED strip lights.

Compatible with product code 20151 (White and Warm-White single color versions).

Installation

• If possible, test strip rope light before cutting it, which would help in troubleshooting if it does not light up after installing rectifier.
• Check that the strip rope light is properly cut at one of the designated cut marks.
• Check that the correct end of strip rope light is identified (the end that has the "+" marks, as circled in blue color of Figure A).
• Insert pointed end of "H" pin into the conductors of strip light (Figure B).
• Attach connector of rectifier to "H" pin, paying attention to the relative positions of the Brown and Blue wires inside the connector (Figure C).
• To make the connection waterproof after testing, silicone caulk or similar product should be used to seal it.

Troubleshoot

If strip rope light does not light up after installing rectifier, check that:

• Strip rope light is correctly cut at one of the designated cut marks.
• Orientation of rectifier connector is correct; connections are secure; power outlet has power.
• One section has "-" end and other section has "+" end connected to the coupler.
• Pins of coupler are lined up with the conductors of the two sections.
• Rectifier is attached to correct end of strip light.