• Color-changing RGB controller with 433MHz radio frequency (RF) wireless remote
• Selects static colors and dynamic modes; adjusts brightness and speed
• 12V-24V DC input, 2 channels, 6A max per channel (12A max total)
• Energy efficient; long distance signal transmission of up to 30m
• For use with color-changing LED strips and modules

Description

This easy-to-use RF controller allows the user to select static colors and various dynamic modes, as well as adjust the brightness and speed of dynamic modes, of color-changing LED strips and modules.  12V or 24V DC power may be connected to the controller via wires or 5mm DC jack.

Programming Controller

Right out of the box, the remote and controller should be paired already. If re-programming is necessary, follow directions below.  The upper-most button on the remote (normally used for increasing brightness/speed) will be used.  Let’s call this button “A”.

To pair:

• Cut off power to controller and wait at least 10 seconds.
• Supply power to controller and, within 3 seconds, press and release the “A” button on remote once.
• If successful, light would blink 3 times slowly.  Repeat above two steps if unsuccessful.

To unpair:

• Cut off power to controller and wait at least 10 seconds.
• Supply power to controller and, within 3 seconds, press and release the “A” button on remote 5 times.
• If successful, light would blink 6 times quickly.  Repeat above two steps if unsuccessful.

Note:

• A single remote may control multiple receivers.
• Each receiver may be controlled by up to 4 remotes.

Specifications