• Outputs vibrant RGB color-changing light and able to adjust color-temperature between warm-white and white (3000 K ~ 6000 K)
• Advanced COB design coupled with ultra-high LED density (840 LEDs/meter) for uniform glow without distinct hot spots
• IP66 waterproof rating (silicone sleeve), suitable for damp locations
• Cuttable at designated cut marks (approx. every 1.4”) to suit various length requirements
• Adhesive back for easy installation on dry, flat, smooth, non-porous surfaces

Description

This high quality, 24-volt, water-resistant flexible LED strip utilizes RGB LEDs for vibrant colors, as well as dedicated white and warm-white LEDs for crisp white and inviting warm-white light.  The ability to change colors and adjust color temperature is unique with this LED strip.  It features COB design with an ultra-high LED density, especially suited for applications that call for uniform glow throughout the length of the LED strip, reducing the appearance of hot spots.  The versatility of this LED strip is a perfect choice where available space is limited and multiple light colors are required.

Note

• Must be used with compatible power supply and RGB-CCT controller.
• Minimum bending radius is 5 cm (2").
• Unused wires of LED strip must be isolated to prevent potential short circuit.
• Unroll LED strip completely before powering on.
• Test all components before cutting or permanently mounting the strip.
• Do not lengthen LED strip by directly connecting additional strips to it; additional lengths should be wired in parallel (controller and power supply must be of adequate capacity).
• Although LED strip comes with double sided tape on the back, silicone is difficult to adhere to, therefore use of additional mounting hardware is recommended.
• Not compatible with mounting clip (product code 2340).
• Specs based on factory testing of 1m lengths; voltage drop is greater on 12V strips than their respective 24V versions.
• For best results, power LED strip from both ends whenever possible.
• Due to its high power, it is strongly recommended to mount LED strip on aluminum channels to facilitate proper heat dissipation.

Specifications