• Stylish design
• Static and auto color-changing modes for mood lighting
• Touch-sensitive RF remote
• Anti-glare, non-flickering, non-flashing LED light source
• Long life of ~50,000 hours

Description

This stylish LED lamp adds a modern touch to any room decor. Great for use in households, hotels, bars, cafes, etc. to add some colors to the atmosphere, setting various moods.

The touch-sensitive wireless RF remote is easy to operation. When a setting calls for the use of multiple lamps, all lamps may be prgrammed to operate by a single remote, eliminating the need to fumble through multiple remotes.

Programming of Lamp

By default, the lamp has been programmed to operate with the included remote. Programming, if necessary, would be as follows:

• Disconnect DC jack between lamp and AC adapter, and remove a battery from remote.
• Reinstall battery in remote and immediately reconnect DC jack between lamp and AC adapter.
• Within 4 seconds, press "Dim" key (labeled as "7" in manual) immediately followed by the "On" key (labeled as "1" in manual).

If the procedure is done properly, the lamp will show Blue color. Repeat above steps if programming is unsuccessful.

Note

To enter auto color-changing mode:

• When lamp is on (in static mode), press "On" key again to enable gradual-change mode.
• When in gradual-change mode, press "On" key again to enable abrupt-change mode.
• When in auto color-changing mode, pressing "On" key toggles between gradual-change and abrupt-change modes.

To exit auto color-changing mode:

• Press "Off" key to turn lamp off, then press "On" key to turn it back on.

Troubleshooting

When power is first applied to lamp, it should light up for a few seconds, then stays off. If lamp doesn't light up or keeps flashing:

• Using a hairdryer, check that power outlet is energized.
• Check that indicator light on AC adapter stays solidly lit when it is plugged into power outlet.

If lamp does not respond to remote:

• Check that all connections (AC adapter to power outlet and to lamp) are secure.
• Remove battery cover in remote; using a small flat head screwdriver, stretch "+" terminal springs in the battery compartment a little; install 2x fresh AAA batteries in the correct orientation.
• Disconnect AC adapter from lamp; reconnect.
• Press "Off" key on remote; turn lamp back on by pressing "On" key.
• Re-program lamp to operate with remote, if necessary.

Items Included

• (1x) LED mood light
• (1x) wireless RF remote
• (1x) AC adapter
• (1x) base
• (1x) instruction manual

Specifications